ASINOL Bumper Paint Spray is a high-quality, fast-drying structural coating for the restoration of the typical plastic surfaces of vehicle parts such as bumpers, exterior mirrors and spoilers, or as an effect spray. br />>>color tone/>>>p>
must be clean, free of grease and release agents.
>li>very good adhesion to metal, wood and hard plastics.>
>pre-treatment / cleaning >>>>>>p>
pre-cleaning with ASINOL Silicone Remover
>br />>special properties >br />>p>
very good coverage
abrasive and non-chalking
>li>coatable with all conventional one-component spray paint cans >li>highest resistance to chemical and mechanical loads >ul>
preparation: shake can vigorously before use
>spray cycles: test spraying - spraying distance approx. 20 - 30 cm 2 - 3 spraying cycles. dry film thickness of 40 - 50 µm. >>flowering time: 3 - 5 min. between spraying cycles >li>end of work: after use turn spray can upside down and spray nozzle empty, this prevents the paint material in the nozzle head from drying out/>dry: after approx. 10 min.
Dust dry: after approx. 1- 2 h.
Grip dry: after approx. 24 h.
Ab +10°C. and up to 80% relative humidity
Well sealed in cool, dry rooms, storable for 2 years.
Labelling according to Regulation (EC) No. 1272/2008:
(P101) If medical advice is required, have packaging or identification label ready. (P102) Keep out of the reach of children. (P103) Read identification label before use.
(H22/>(H222) Extremely flammable aerosol (H229) Container is pressurized; may burst when heated (H319) Causes severe eye irritation. (H336) May cause drowsiness and dizziness. (EUH066) Repeated exposure may cause skin dryness or cracking.
>>Safety Instructions >br />(P210) Keep away from heat, hot surfaces, sparks, naked flames and other sources of ignitionkeep away. Do not smoke. (P251) Do not pierce or burn, even after use. (P305) In case of contact with eyes: (P351) Rinse carefully with water for a few minutes. (P338) Remove any contact lenses if possible. Continue rinsing. (P405) Keep locked up. (P410) Keep out of sunlight. (P412) Do not expose to temperatures exceeding 50 °C. (P501a) Dispose of contents/container in accordance with local/regional/national/international regulations.